|
img Classic
Re: Akula, Ruslan, Stalker, device discussion and replications. « Reply #667 on: 2023-09-25, 21:20:38 »
Full Member
***
Posts: 188
Quote from: NickZ on 2023-09-25, 19:57:23
That's great Ape, I hope it works for you.
Thanks, for answering.
The only thing that I can add is the idea that this is not a HV plus lower voltage additive system.
No amount of adding these two frequencies together will have any OU effect, ever. No matter what.
This is a interruptor type circuit instead. Just keep that in mind. Otherwise, it is just another boost circuit or inverter circuit. And that's all.
Your friend,
NickZ
Usually low voltage is used for signal generation, high voltage at high frequency in standing wave is the place where the “magic” is happening in respect with correct length of wires, capacity and inductance.
See quote:
Quote
If there is a 180 ° phase difference ( equal capacities ) between the electron currents, then we are dealing with " bellies " and " nodes " which move along the wire pairs. Similarly, moving the aether inflow locations where So zero point energy is absorbed .
Logical is that the amount of zero point energy that is absorbed per unit of time, is dependant on the frequency and the amplitude of the injected alternating current.
An open end (other than at the said capacitors ) acts as a mirror, and so the length of the two wires have to be not only equal, but must also be a multiple of a half wave-length, to get pure " bellies " and " nodes " and resonance, making maximum absorption of zero-point energy possible. Also, because of the "bellies" is the alternating voltage measured between the wires 2 x as high as the input voltage.
By varying the capacity of one of the capacitors, higher frequencies / super - positions can be achieved , for example, doubling at a phase difference of 135 ° . Also, if the incoming alternating voltage wavelength-wise does not correspond to the lengths of the wires , will the reflections at the end of the wires and the charge and discharge of the capacitors cause the creation of several wave super-positions, which is undesirable; absorbsion of zero point energy remains therefore very small. A "Clean " wave is desirable and higher frequencies result than in higher zero point
energy absorption .
|
Author
Topic: Don Smith Akula, Ruslan, Stalker, device discussion and replications. (Read 47454 times)
