@Aliengrey,
Do not confuse your push-pull frequency with your grenade frequency.
The relationship your talking about is grenade and Tesla frequency.
They can be in ratio 1:1 or 2:1 or 3:1. If your comparing the grenade to that of push-pull it could be higher in ratio. Most folks uses that of 50:1 . That's the push-pull sub of grenade frequency
Max: Where are you getting this information, above. To me, it makes no sense. You can't have the PP frequency of 1:1, 2:1 ... compared to the Kacher frequency.
In the set ups that Itsu and I have, along with Geo had at one time, we are trying to match what we see in the Stalker videos, and the Ruslan videos. If possible. As Stalker copied the Ruslan device. And Ruslan copied the Akula device.
Geo replicated the Akula circuit, and I replicated the Stalker simple kacher and grenade circuit. Which is the same as the Ruslan simple kacher device. Just for some preliminary information about what has been done and tested, and by who. As I have been following this project for a long time.
My Kacher can be tuned to run at the supposed best frequency match to the grenade by just adding or removing turns on the secondary coil.
My Kacher runs at 900KHz to 1.2MHz by just tuning it with ferrite in the core. I don't recommend doing that though, as it will make coils heat up.
My Grenade runs at around 18KHz, to 21KHz, or so. Depending on tuning caps and such. This is using a 37.5m long grenade output coil, as well as a similar sized ground line. My Kacher normally runs around 1MHz, compared to the grenades 18Khz, or so. I have not seen the better matches by tuning to any set calculated frequencies. I just tune to what works best and gives the best results, as I've shown in my videos.
I have mentioned to Alien Grey many times, to build the device, and he will see that those numbers and frequencies that he thinks will work, won't.
And he will see, like Itsu has, that there is nobody home, there. As every self running device ever shown is running on a DIFFERENT frequency.
If that does not tell you anything... well sorry, that's my take on this.
NickZ
feature is available which provides a place all members can chat, either publicly or privately.
Author
Topic: Dally, Shark & Ruslan workbench (Read 309398 times)
