Is not the output rectified and smoothed by a cap? At the frequency involved, ripple should be easy to reduce to a minimal amount. A simple DC current measurement, to go along with the provided DC voltage at the load, was all I was suggesting...
PW
PW: Remember that this type of device has two systems that need to be working together, for any overunity readings to be observed. There is the push pull magnetic induction circuit, and also the Kacher's (controlable HV circuit) supplying the HF signal. Therefore, the input to output readings need both circuits working together to be able to provide for self running. That will not happen while just running the push pull circuit, and taking reading without the Kacher circuit on, as well. So, all that we'll see at this time, is just the less than overunity readings, until the Kacher is tuned and working along with the push pull circuit. And yes, the input to output reading can serve to see what kind of efficiency there is in the push pull circuit, only. But, that will change in the future with the addition of the Kacher signal, on top of the push pull signals. At least, that is the plan. I hope this helps to understand why itsu is seeing such low underunity type of readings at this time. There is a ton of information (and miss information) about this device, too much in fact. Which are trying to make an attempt at understanding and explaining the workings of this device. But, it takes much time to go through it all, and no one will understand what is really going on, until you see it actually working right. And even then, some guys may assume that it's NMR, or some scope or meters reading errors involved, instead, of a device which is harvesting and utilizing the local ambient energies. This is what we are here to find out. I'm almost to the point of jumping into this ball game, again. Just waiting to see itsu's full diagnostics. As well as Vasilli device, kickin ass... NickZ
|
Author
Topic: Dally, Shark & Ruslan workbench (Read 310107 times)
