@Tommey Reed
No free lunch? That's because the universal cook only opens the kitchen on special occasions. hahaha
Really though you are simply playing with leverage as you well mentioned in your video. 10:1 leverage one way also produces 1:10 leverage the other way.
As far as i can gather thus far, the only reason such devices don't work is because we are using the wrong topology. You cannot use a motor as a generator if it has iron laminations. Simply speaking, when the generator coils start producing output it also becomes an electro-magnet and what do electro-magnets and magnets do best? Drag or Cog at 1 which is transfered to the drive motor as 10.
Here is what we are missing.......
Take a look at this video.......
https://www.youtube.com/watch?v=JCUpflizTH4Now imagine if he had two wheels (with all polarities the same facing out) slightly offset and turning with the copper pipe between them.
Now imagine instead of a copper pipe, you had copper wire as shown below.
Shown is a drawing with 10 magnets on a wheel if you are only using a wheel on one side. It could be any number depending on magnet and wheel dimensions.
But, if you have two wheels with 5 magnets each and offset so the copper gets hit from one side then the other and so on, this will provide you with 180 degrees copper atom core swing and if the wheel turns fast enough (but not fast enough to create heat like the copper pipe) you will reach a point where the copper atom cores will start to spin, ALL WITH NO DRAG or COG.
This can be done horizontally or vertically but this is the direction to look. It can be done with only one or a few magnets with one or two sides as small bench tests before anyone start making big systems, but this is the type of designs that follow Spin Conveyance.
In your case, if you put magnets on the end of your bicycle wheel with a stator of copper wires also all around that wheel, it will give the same results as a one wheel system.
One wheel systems should have magnets as NSNSNS, two wheels systems should have magnets all N or S depending on if you are in the northern or southern hemisphere. For northern use all north, for southern use all south. This way since the northern hemisphere is a south gravity pull, the copper atoms will keep moving when the magnets are at their lowest impress that will create a spin and a sway of the coper atom cores.
The copper wires have to go past the magnet diameter so the energy can be removed away from the magnets before they are all paralleled otherwise you risk creating cancellation zones.
@GK
This is also the same for the SM TPU when he says, two fields in opposing directions and what can it produce. It can only produce nothing because the copper atoms in the center pickup will simply seize or STAY. SM analogy was wrong but well intended. If you have a two turn loop field coil, the first turn will be north the second south. If you have two of these with a pick ring in between, the same goes as mentioned above the same field loop polarity should be closest the pick up loop, then they need to be pulsed one, then the other as variable to find the best frequency. This will turn the copper atom cores and produce output. There should be no flyback since the loop have near zero inductance.
wattsup
Author
Topic: Tommey Reed's OverUnity Experiments (Read 5185 times)
