|
That's a pretty interesting video...
I used to design and build micro gas turbines, the newest turbines can easily spin up to 100,000 RPM and some can even reach 500,000.
The biggest issues are high RPM centrifugal forces on the rotor causing vibration and stress fractures. As well as bearing lubrication/heating at high RPM due to the high fluid sheer forces. Most modern micro turbines use air bearings to solve this issue. These issues become much more important if were thinking about running a turbine for any length of time.
On the Tesla turbine having low torque, as an engineer I can safely say it doesn't matter. Most of the critics are confusing work, power and energy again. In fact Work=Force x Distance, so a large force/small distance or small force/large distance can produce the same work. In a Tesla turbine the RPM is the Distance travelled and the drag on the disk the applied Force. So in the Tesla Turbine were basically taking a small force and applying it over a long distance. The distance is the circular path the fluid takes winding inward to the outlet.
The design is brilliant because most radial bucket type water or steam turbines such as a Pelton only extract energy during less than one revolution or 360 degrees. In the Tesla turbine the working fluid could act through ten or more revolutions inward encompassing 3600 degrees. Thus the distance travelled is almost 10x greater for work to be performed increasing the power output.
Regards
AC
---------------------------
Comprehend and Copy Nature... Viktor Schauberger
“The first principle is that you must not fool yourself and you are the easiest person to fool.”― Richard P. Feynman
|
feature is available which provides a place all members can chat, either publicly or privately.
Author
Topic: Tesla turbine cold steam 135f water looks promising (Read 1281 times)
